OVMS Twizy Firmware V3.8.1

Firmware: http://dexters-web.de/f/tw/OVMS-Twizy-3.8.1.zip Framework V2.9.1: - DIAG mode automatically started when booting without SIM, shown by constant green LED and no longer terminated by inactivity - DIAG mode SMS and MSG command output now prefixes all message lines with "# " and terminates with "#." on a single line (easier to process from tools like the perl client) - Added "CARON" alert for vehicle stopped turned on (first after 15 minutes, followups every 60 minutes) Twizy 3.8.1: - Trip report energy usage now based on odometer and also showing SOC gains - Charge power & energy, battery voltage & current now also in framework (for App display and tools) - Alert on SimpleConsole key presses when vehicle parked (i.e. for external alarm sensors) - Charge power limiter Charge power limiting is done via feature 7. This is no configuration stored in the BMS/charger, the module needs to stay connected. Charge power can be slightly above the configuration for short periods, normally only few seconds. Feature 7 can be set to levels within range 0-7, with 0 & 7 meaning "no limit". CAN write access needs to be granted. Feature 7 is volatile and needs to be checked & reset before charging. Levels 0-7 translate to about... charge current = level x 5A charge power = level x 300W These are at the battery, power will be higher by charge efficiency at the socket, so about 11-16% depending on charge state. At the socket, the levels translate to about: 1 1.6 A 350 W 2 3.1 A 700 W 3 4.7 A 1,050 W 4 6.3 A 1,400 W 5 7.8 A 1,750 W 6 9.4 A 2,100 W 7 10 A 2,230 W Charge time estimation adapts to the reduced power. Source: https://github.com/openvehicles/Open-Vehicle-Monitoring-System/